Search results for 'diametrically magnetized'

50mm long x 25mm wide x 12mm thick Neodymium Block Magnet - NdFeB N38 - Nickel Plated - Magnetized through 12mm thickness Learn More

This diametrically magnetized magnet was originally designed for the Melexsis MLX90316 Rotary Position Sensor IC. Cylinder magnets are usually magnetized so that the poles are on the ends of the magnet. This piece is setup so that the poles are on the sides of the magnet. This makes the magnets stack up edgewise. The side effect is that this magnet is perfect for magnetic jewelry. See our magnetic bracelet combo pack.

Learn More

This large ring magnet is roughly the same size as our D2506 disc magnet with a 12.5mm center hole. It can hold a 1/2 inch steel plate with about 20 lbs of force. Learn More

N35 is the weakest NdFeB grade available. The N35 and N50 grades of the 4x2 disc magnet were requested specifically for rubik's cube modifications by magnetic cubing expert DMCubing. Check out his channel for great instructional videos on how to upgrade your cubes with some rare earth magnets! Learn More

This thin rectangular plate magnet is perfect for sewing into light fabrics. The large 5x12mm surface area gives plenty of holding strength, but the thin profile ensures that the field does not extend too far. This one can hold up to 6 lbs. Learn More

A thin gold plated magnet in a low grade (N35) material. Great for paper crafts such as embedding into a box or cardboard closure. Learn More

A good sized cylinder magnet that is a little bit less than 1/2 inch in diameter x 1 inch long. Like all cylinders, this one is best used when you need a deep magnetic field and not merely holding power. Learn More